The way to Tighten Hands on a Genre

Dangling hands on the surface of a clock do not do anyone any good. The clock may continue to operate, but it certainly doesn’t longer tell you the moment, and if you possess a clock that chimes on the hour and the half hour, then it may not let out one note. Several clock hands are held to the surface of a spreadsheet by friction and a little nut, and it takes just a very simple repair to tighten them. If the fingers on your clock refuse to stay tight, then you may have to replace the nut or the clock hands.

Catch the hand against the clock shaft. Friction holds the hand on the shaft, and pushing it back on the shaft will tighten it. Once you tighten the hour hand, rotate it too the suitable moment.

Tighten the nut on the end of the shaft holding the second hand. Employing needle-nose pliers can allow you to grasp this little nut. This nut holds the second hand in place. Rotate the second hand to the correct moment.

Push the stem on the rear of the second hand into the opening on the end of the shaft in case your clock has a second hand. Friction holds the second hand at the little opening at the end of the shaft.

Verify the hands when you tighten them. Make sure nothing obstructs the fingers or they catch on each other. Carefully bend the fingers to whip them if needed.

See related